Need some "rear end work"
#1
NAZI mod
Thread Starter
Join Date: Oct 2008
Location: Virginia Beach
Posts: 1,218,276
Likes: 0
Received 0 Likes
on
0 Posts
Need some "rear end work"
I need a place that will clean up a horrible attempt at a weld by the previous owner of my recently acquired 9" rear. I want the weld cleaned up and a new, BETTER bead layed down to seal the cover back.
My guess is that the insides went BOOOOOM at one point, bent the cover out a bit and he jimmy-rigged this shit on there. The rest of the housing is fine, just need this weld cleaned and repaired. I already it stripped down to the bare housing, I would also like the entire thing cleaned up while whoever is fixing it is at it.
Not looking to spend a fortune either.
My guess is that the insides went BOOOOOM at one point, bent the cover out a bit and he jimmy-rigged this shit on there. The rest of the housing is fine, just need this weld cleaned and repaired. I already it stripped down to the bare housing, I would also like the entire thing cleaned up while whoever is fixing it is at it.
Not looking to spend a fortune either.
#4
NAZI mod
Thread Starter
Join Date: Oct 2008
Location: Virginia Beach
Posts: 1,218,276
Likes: 0
Received 0 Likes
on
0 Posts
#8
baller/dickbutt#69
Join Date: Nov 2002
Location: hampton
Posts: 16,059
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need some "rear end work"
#10
NAZI mod
Thread Starter
Join Date: Oct 2008
Location: Virginia Beach
Posts: 1,218,276
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need some "rear end work"
LOL, ok.
The rear was actually pieced together from stamped components and then jig welded together.
That just might work...we should try it AT THE SAME TIME.
The rear was actually pieced together from stamped components and then jig welded together.
That just might work...we should try it AT THE SAME TIME.