program nissan key fob
#3
I <3 Hikki Chan!
Join Date: Dec 2002
Location: 757
Posts: 4,313
Likes: 0
Received 0 Likes
on
0 Posts
Re: program nissan key phob
pretty easy, leave ur driver door open and make sure its unlocked...take ur key, insert it into the ignition and pull it out over and over until either the car beeps, or the doors lock, or the emergency flashers start flashing or the security light flashes (i forget what) once that happens insert the key and turn it to ON . press one button on the fob, then press BOTH buttons. remove key. try fob. if it doesnt work PM me and ill find out forrela (i havent done it in a while)
#4
I am the way.
Join Date: Nov 2002
Location: Virginia Beach, VA
Posts: 5,128
Likes: 0
Received 0 Likes
on
0 Posts
Re: program nissan key phob
Older Fords used this trick:
Unplug the battery in the car long enough to drain backups, like 30 seconds. Plug everything back up and then use the FOB, it would pick up the first signal it received.
I had a 99 Ford Escort and this worked like a charm.
Unplug the battery in the car long enough to drain backups, like 30 seconds. Plug everything back up and then use the FOB, it would pick up the first signal it received.
I had a 99 Ford Escort and this worked like a charm.
#8
Registered Member
Join Date: Oct 2004
Location: Chesapeake
Posts: 643
Likes: 0
Received 0 Likes
on
0 Posts
Re: program nissan key fob
1. Close all doors and lock all doors
2. Insert and remove the key from the ignition key cylinder more than six times within 10 seconds.
(The hazard warning lamp will then flash.)
NOTE:
Key should be withdrawn from ignition key cylinder completely each time.
NOTE:
Do not rush the insertion/removal key cycling process. The side
marker/tail/license lamps and interior illumination will flash twice when this step is
accurately completed.
3. Insert key on ignition key cylinder and turn ignition key switch to "AAC" position
At this time, the new ID code is entered and original (previous) ID codes are erase.
4. Press any button on the new remote controller once. (The hazard warning lamp will then flash)
NOTE:
Do not press the button more than one time in the above step. If the button
is pressed more than one time, the programming procedure will not be successful.
The side marker/tail/license lamps and interior illumination will flash twice when this
step is accurately completed and programming is successful.
2. Insert and remove the key from the ignition key cylinder more than six times within 10 seconds.
(The hazard warning lamp will then flash.)
NOTE:
Key should be withdrawn from ignition key cylinder completely each time.
NOTE:
Do not rush the insertion/removal key cycling process. The side
marker/tail/license lamps and interior illumination will flash twice when this step is
accurately completed.
3. Insert key on ignition key cylinder and turn ignition key switch to "AAC" position
At this time, the new ID code is entered and original (previous) ID codes are erase.
4. Press any button on the new remote controller once. (The hazard warning lamp will then flash)
NOTE:
Do not press the button more than one time in the above step. If the button
is pressed more than one time, the programming procedure will not be successful.
The side marker/tail/license lamps and interior illumination will flash twice when this
step is accurately completed and programming is successful.
Thread
Thread Starter
Forum
Replies
Last Post