DSS 3.9 axles, and custom water to air intercoller setup
#12
Re: DSS 3.9 axles, and custom water to air intercoller setup
they are definately 3.9"s, i had one rebuilt by DSS and it was definately a 3.9, the car i ran them in was a tube chasis race car, and they were fit into my true street car, but then i upgraded to 5.9"s and 36mm hubs... i thought they were stock size hubs because they are still 32mm
#13
Re: DSS 3.9 axles, and custom water to air intercoller setup
If they have 32mm nuts there is no way in hell try are 3.9 but believe what you want. You're the one who looks like an idiot not the other 3 ppl that are saying different
#14
Re: DSS 3.9 axles, and custom water to air intercoller setup
ok i got off the phone with DSS to end the this discussion... any of you can do the same if you would like... You guys are right about the hubs they are a bigger 26 spline... however I am accurate about the axle nut size... even though DSS sends the 3.9 axles out w/ a 36,, nut, they are interchangeable w/ a stock civic or integra 32mm nut, they have the same thread size/ pitch... I will also include the hubs w/ the axles, i thought they were stock hubs since i used stock axel nuts and the fact that it is still a 26 spline axle however it is in fact a bigger spline... Thank you for the correction, and no need to call me an idiot...
Thread
Thread Starter
Forum
Replies
Last Post
turbo123
Engine / Exhaust / Drivetrain
12
03-18-2011 07:49 AM