need some gaskets made
05-26-2006, 12:11 PM
#12
Bath salt trippin'
Thread Starter
Join Date: May 2004
Location: Nova
Posts: 9,240
Likes: 0
Received 0 Likes
on
0 Posts
Re: need some gaskets made
ok so, i dont even need them made.
if anyone knows a place where i can just get 3 inch gaskets for exhaust (2 bolt) PLEASE let me know.
if anyone knows a place where i can just get 3 inch gaskets for exhaust (2 bolt) PLEASE let me know.
06-01-2006, 03:15 AM
#14
DSM builder/tuner
Join Date: Oct 2003
Location: NoVA
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
Re: need some gaskets made
I made my own exhaust flange and O2 gaskets out of .048 sheet copper used for roofing. I just traced the flanges and cut them out with a plasma cutter. I coat them with Permatex Copper Coat, allow it to air dry(10-15mins) and become tacky before install.
Works great and was necessity for the Bullseye ex. housings I use. Their O2 outlets are a little different from the factory DSM style. The pattern is close to factory, but they increased the size of the outlets causing an offset. I had to facbricate my own downpipe flange, DP and O2 gasket. Off the shelf items require porting or cutting to align properly.
Works great and was necessity for the Bullseye ex. housings I use. Their O2 outlets are a little different from the factory DSM style. The pattern is close to factory, but they increased the size of the outlets causing an offset. I had to facbricate my own downpipe flange, DP and O2 gasket. Off the shelf items require porting or cutting to align properly.
Thread
Thread Starter
Forum
Replies
Last Post