hey guys i got a problem with my 1993 bronco. it has a push button auto 4wd and it use to work all 4 hi and 4 low. then it just stopped going into low range but it was still clicking in the the kick panel on the passenger side like it was trying to engage. but just last week it stopped clicking and now it wont even go into 4wd at all... hi or low!! any ideas what it could be... thanks for any help you can give me!!

 

more snow tomorrow ahhhhhhhhhhhhhhhhhh @!@@@

no cel light ?? or maintinence required light ?
low oil? i dunno about your truck but my 4runner needs a certain amount of oil to work the awd ive noticed this the past few years

 

i know i know!!!!! what a bad time to stop working!!!!!!

 

You have a chilton manual? I had a bad switch in my 91 f150, never got around to fixing it, think I used 4wd once or twice.

 

this is where i would start if it was me

1. check all diffs make sure no metal fragments are on the fill plug or drain plug.
2. Make sure fluid in diffs isnt shit anyway or if u have any at all
3. if that dont work im guessing u have auto locking hubs and just a switch if i read right...make sure the hubs are enganging at all u can tell this by lifting front end while in 4wd and turning wheels manuely. if front driveshaft spins not ur problem.
4 if it doesnt then it is
5. make sure ur shits is even hooked up for one joints could of went bad

 

IIRC the electronic 4wd systems on fords have like this hub that goes bad. It is a very well known problem on these. I changed one out on an exploder but never on a bronco.

 

cool... ill check these things...

 

Find out anything yet?

 

No not yet.. I have to finish digging out of the snow its got about 2 feet around it right now!I plan on doing it saturday.. When I find out what it is ill post it up.. Thanks again!

 

http://www.explorerforum.com/forums/...d.php?t=202166