Input shaft bearing d series changed it still making noise
#1
Registered Member
Thread Starter
Join Date: Sep 2006
Location: Virginia Beach
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
Input shaft bearing d series changed it still making noise
Ok so I have a d16y7 in my wife's 99 and the transmission was making noise
When the clutch pedal was up so I replaced the input shaft bearing and it's still making the
Noise I checked the clearences and bearing play when I had it apart
And everything else was fine I'm clueless right now and a part of me wants to
Brake down and cry any suggestions ?
When the clutch pedal was up so I replaced the input shaft bearing and it's still making the
Noise I checked the clearences and bearing play when I had it apart
And everything else was fine I'm clueless right now and a part of me wants to
Brake down and cry any suggestions ?
#2
Registered Member
Thread Starter
Join Date: Sep 2006
Location: Virginia Beach
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
Re: Input shaft bearing d series changed it still making noise
Has anyone ever had a problem with the output shaft bearing making a rolling whirrling type of noise.
#5
Registered Member
Thread Starter
Join Date: Sep 2006
Location: Virginia Beach
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
Re: Input shaft bearing d series changed it still making noise
replaced the clutch, pressure plate, throwout bearing and pilot too
the throwout bearing typically would make noise when the clutch pedal is pushed in not when the pedal is up and the
clutch is disengaged
the throwout bearing typically would make noise when the clutch pedal is pushed in not when the pedal is up and the
clutch is disengaged
Last edited by crxmatt; 02-14-2013 at 07:51 PM.
#6
Registered member
Join Date: Jul 2003
Location: somewhere
Posts: 714
Likes: 0
Received 0 Likes
on
0 Posts
Re: Input shaft bearing d series changed it still making noise
CRXMATT.. I thought a throw out bearing would make noise when the pedal is up then go away once the pedal was pressed down.. ?? Just wondering..?
#7
Input shaft bearing d series changed it still making noise
No throw out will make noise when the clutch is engaged. What kinda throw out did you install? If its eBay you need a new one. Bearings inside the trans make noise when you're in gear and driving, it'll be a whining noise. So if it makes noise in neutral with the clutch engaged its the throw out. Pilots rarely make noise but cause the clutch to be hard to push do to the input shaft not lining up with the center of the crank, if it does make noise it will be while the clutch is dis-engaged.
#10
Registered Member
Thread Starter
Join Date: Sep 2006
Location: Virginia Beach
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
Re: Input shaft bearing d series changed it still making noise
I'm starting to suspect that as well just sucks having to take
Everything apart again
Everything apart again