marco

i have to quote you wrong on that i had a cb7 92 lx had it four years put the h22a1 in it a month after having it and used a 93 ex harness cause my lx one was full of oil

ZebraEJ8

You must have been using a jumper or something because up until 94 the ex came with the f22a6 which is non vtec...

marco

no sir i do not believe in jumper harnesses at all we make harnesses

kwh924

Exactly the 93 ex is not VTEC so if you want to use VTEC you need a VTEC ECU off of something else with and if you were using the 93 harness then I take it VTEC was hardwired straight from the ECU?

adamfrom804

i have a 95 accord ex vtec 5 speed what would i have to do to put an h22 head on it and make it run again? Also need to know about how long it would take i know i can do all the work myself done ity to many bseries before. just dont know much about f and h series. all GOOD knowledge is appreciated!

marco

YEs my 92lx cb7 stock harrness wire up vtec use p28 chipped.... or p13 stock thats the way it will work properly..... hondata is great aem is the best but both cost a little extra money

marco

im not sure but for the money i would go for a k24 swap not knowing wat your money is like.. but i think the thaT CONVERSION is like an ls vtec... i was going to do this but i felt like the h22a1 swap was a better bang for my buck

urbnredneck

finally found and fixed my oil leak. It was an o ring in my oil filter adapter. Thank god it was a simple fix.