ECU code problem
#1
Registered Member
Thread Starter
Join Date: Sep 2007
Location: 804
Posts: 772
Likes: 0
Received 0 Likes
on
0 Posts
ECU code problem
my ls swap is throwing the "cyp" code.I looked it up and all it says is a bad sensor,but it dont say which one.I need to figure this out,any suggestions?
#3
Digital Life
Join Date: Feb 2006
Location: Worldwide
Posts: 4,850
Likes: 0
Received 0 Likes
on
0 Posts
Re: ECU code problem
CYP Sensor (Cylinder)
defective circuit or unplugged / defective sensor
Check it out. If its ok, check your timing, and make sure you dont have your air intake sensor and IACV mixed up.
defective circuit or unplugged / defective sensor
Check it out. If its ok, check your timing, and make sure you dont have your air intake sensor and IACV mixed up.
#5
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: ECU code problem
It could be the wiring too, don't assume the sensor is bad yet. With an engine swap I always assume it's the wiring first and troubleshoot from there. You'd do that too if you'd see the swap wiring atrocity that I've seen.
CYP is cylinder 1 position sensor if I remember correctly.
CYP is cylinder 1 position sensor if I remember correctly.
Thread
Thread Starter
Forum
Replies
Last Post