h22 help
#4
Re: h22 help
naw you blaze it more with a h22 h2b si tranny kit. go bisimoto style he runs a h22 motor with a si b-series tranny . but with cams i would go with SKUNK 2 stage 2 cams. or some TODA's
#6
Registered Member
Join Date: Mar 2008
Location: Dinwiddie
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
#8
Re: h22 help
I wouldnt even put cams in it. put a nice header, nice exhaust and get a good tune. otherwise id start with the bottom end first as far as a build goes. the bottom ends are for sure the weak link in those motors. you can get some mahl (not sure on exact spelling) pistons for pretty cheap and they are the only pistons for that motor that allow stock sleeves. any other pistons and you will need to sleeve the block. with a sleeved block and a forged rod and piston combo (high compression) you can put any cams in it you want, and will be ultra reliable n/a motor. but with any set of cams you get, you need to upgrade the springs and retainers. bottom line is I dont think you are going to see a very noticeable difference when upgrading to a stage 1 cam, and you wont be able to run a bigger cam with oem pistons if I remember correctly.
#9
Registered Member
Thread Starter
Join Date: Oct 2008
Location: Nova
Posts: 212
Likes: 0
Received 0 Likes
on
0 Posts
Re: h22 help
So u would recommend building the bottom end first such
Such as piston rods bearings n shyt like that....wut brand would u recommend for all motor
Such as piston rods bearings n shyt like that....wut brand would u recommend for all motor