no VTEC.. lets see what ya'll think
#11
Registered Member
Thread Starter
Join Date: Feb 2003
Location: Va Beach
Posts: 1,146
Likes: 0
Received 0 Likes
on
0 Posts
Re: no VTEC.. lets see what ya'll think
yup it is .. the lma's are brand new and it dont beleive it is a spun rod bearing .. been there dont that .. this is a bit different noise it is def. a ticking noise noise not really a knock or tap.i beleive it is the rocker or somthing to do with it .. but we will see car is going to the shop toamrow.
#12
Team Ultraspeed
Join Date: Nov 2002
Location: Nonya (hint: VaBch)
Posts: 1,148
Likes: 0
Received 0 Likes
on
0 Posts
Re: no VTEC.. lets see what ya'll think
I guess is that when you replaced your LMA's that one of the vtec lock pins fell out for one of your rockers. Esohsee beat to it...but that's my guess. Rule of troubleshooting..."go back to the last thing you did before the problem"
LMA's...to remove them...you have to remove your rockers. Those pins slide out so easily. It's happen to me before, but I've been lucky to see them fall out
LMA's...to remove them...you have to remove your rockers. Those pins slide out so easily. It's happen to me before, but I've been lucky to see them fall out
#13
I'm worse drugged
Join Date: Mar 2005
Location: Va beach
Posts: 592
Likes: 0
Received 0 Likes
on
0 Posts
Re: no VTEC.. lets see what ya'll think
if the lmas are "BRAND SPANKING NEW" they need to be pre soaked in oil or else they will fail prematurely. never had the prob but read a lot of this happening. i would check the rocker pins. see if all are in place. then redo valve lash. if the noise persists. send to someone you trust.oh yea... check if your timing belt is slapping around. helms say the long side should deflect about an inch. i usually turn the motor over manually while checking tension.
#15
Registered Member
Thread Starter
Join Date: Feb 2003
Location: Va Beach
Posts: 1,146
Likes: 0
Received 0 Likes
on
0 Posts
Re: no VTEC.. lets see what ya'll think
lol ... the tick noiuse was an exhaust leak .. cuz my waste gate came loose..... lol.... now waiting to find my vtec problem...
Thread
Thread Starter
Forum
Replies
Last Post