randomly goes into limp mode
07-06-2009, 12:41 PM
#11
Digital Life
Join Date: Feb 2006
Location: Worldwide
Posts: 4,850
Likes: 0
Received 0 Likes
on
0 Posts
Re: randomly goes into limp mode
how can you check the codes if the led isn't flashing... it's just solid.
i redid my mpfi wiring and made it look cleaner as well as wiring up my lc-1 and i think i fixed it? i test drove it and it worked fine... my only concern is that it was always random when it failed on me, so i guess i'll see...
i redid my mpfi wiring and made it look cleaner as well as wiring up my lc-1 and i think i fixed it? i test drove it and it worked fine... my only concern is that it was always random when it failed on me, so i guess i'll see...
07-06-2009, 01:10 PM
#12
Registered Member
Thread Starter
Join Date: Apr 2008
Location: the internet...
Posts: 537
Likes: 0
Received 0 Likes
on
0 Posts
Re: randomly goes into limp mode
no, it went away... lol
a solid led is code 0, which means faulty ecu... hondas are all alike in that they can run off just a few sensors (tps, etc...) with rev limit ~3k... it's like enough to "limp" your car home haha
but now it's working fine... lc-1 was showing 9-14 afr while i was driving, so im not sure if the ecu has gathered enough info to start using the o2 sensor yet... no code though... weird?
a solid led is code 0, which means faulty ecu... hondas are all alike in that they can run off just a few sensors (tps, etc...) with rev limit ~3k... it's like enough to "limp" your car home haha
but now it's working fine... lc-1 was showing 9-14 afr while i was driving, so im not sure if the ecu has gathered enough info to start using the o2 sensor yet... no code though... weird?
Thread
Thread Starter
Forum
Replies
Last Post