NAJDMDC4

ok well im relatively new to 240s. i just picked up a 89 240sx with a neo rb25 swap. the guy i picked it up from had put the neo rb25 swap in with the neo rb25 tranny but put a ka shifter and i need to replace the shifter bushing cause it is very bad. so to replace the shifter bushing do i just get a rb25 shifter bushing, ka shifter bushing, or would any 240sx shifter bushing work

Fabrik8

Which shifter bushing...? The bushing between the chassis and the shift lever, the bushing between the shift lever and the shift linkage, which one?

eng

I'm going to assume he's talking about the plastic bushing that's on the end of the shift lever. In which case one from almost any RWD Nissan should work.

Here's the Nissan part number if you want to buy a new one: 32861

JDM180SX

this is a better replacement for plastic stock unit...this is whats on mine

CUSCO brass bushing

http://www.phase2motortrend.com/cushbu24.html

NAJDMDC4

yea its the one at the end of the shift lever. i just wanted to make sure I'm new to 240s so i wasn't sure. thanks guys

eng

Sure its better, but its also way more expensive … $35 vs ~$2.

JDM180SX

true...i think i got mine for 20.00 a few years ago.

NAJDMDC4

hey man i got the bushing in but i was wondering is it just supposed to fit on their and be loose or is it supposed to be loose

JDM180SX

did you get oem or the brass one? when i got my brass one on it was a little loose, but i took some pliers and compressed it on and it was good to go.

NAJDMDC4

i bought the oem one for now but it wouldnt fit at all so would i jam it in or..??