Why does my clutch in 91 civic have no pressure??
#11
Registered Member
Thread Starter
Join Date: Feb 2009
Location: Roanoke, Va
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
Re: Why does my clutch in 91 civic have no pressure??
yeah its new throw out bearing... is it possiable for the clutch cable to stretched or maybe the clutch or pressure plate is defective
#12
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: Why does my clutch in 91 civic have no pressure??
I suppose it's possible. It's not very likely though. Again, did you break the clutch in properly?
#13
Registered Member
Thread Starter
Join Date: Feb 2009
Location: Roanoke, Va
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
Re: Why does my clutch in 91 civic have no pressure??
its only been in for two days. and as soon as i started putting clutch cable on i could tell then something was right cause it had so much slack in it. i had to tighten it all way down for it have any pressure
#16
Re: Why does my clutch in 91 civic have no pressure??
well the clutch and the flywheel being wrong could be a potential problem but it doesnt explain why your not getting pressure, i would say it has something to do with your Clutch master cylinder or the slave stoner but sounds to me that either your master cylinder is bad or the lines not getting properly bled out
#17
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: Why does my clutch in 91 civic have no pressure??
well the clutch and the flywheel being wrong could be a potential problem but it doesnt explain why your not getting pressure, i would say it has something to do with your Clutch master cylinder or the slave stoner but sounds to me that either your master cylinder is bad or the lines not getting properly bled out
HINT #1: It's a cable clutch, because it's a 1991 transmission. It says so right in the thread.
HINT #2: It's really, really, really difficult to bleed a clutch cable.
Last edited by Fabrik8; 03-28-2010 at 10:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Stea1thy
Engine / Exhaust / Drivetrain
2
09-25-2009 09:14 AM
dirty1thirdee
Engine / Exhaust / Drivetrain
3
04-04-2009 05:51 AM