black6gen

Ok just pulled off a set of stock injectors from my boys WRX. They are 440cc and high impeadance and saturated, the only thing is that there are 2 little pices of plastic stoping the injectors from cliping up to my d-series civic. If i shave the piecies off and make sure the connections are all god they should work right?

Well any info on this will be greatly apriciated!!!!!!!

zimzorga

not sure, but i can tell you that they will shoot a whole lot more fuel into your engine, possibly flooding it to the point where it wont work. i know that when you put some dsm450s into a civic you need a something (SAFC) to make them shoot less fuel into your engine. unless you need all the fuel, ie massive amounts of boost. other then that, you will probobly need a resister box if your civic doesnt have one.

drifterJERRY

arnt the WRX injectors sidefeed?

black6gen

Im no they are top fed.

hondazccivic

The only reason for running these injectors on your car is if your boosting it, or is already boosted. But ya I believe aslong as there is a connection and they are in the manifold properly and fuel rail it will work. But don't put them on until you tune it, or you will fuck your engine up.

black6gen

Thats exactly the reason i am asking this ? is because i plan on running a T3 with about 8psi.

hondazccivic

ok, well most people use injectors from other cars when they are boosting a civic, or something similiar. So of course some modification will be needed. So all your looking for as a finished install is, a good seal (so no fuel is leaking), and a good electrical connection. Let me know how it goes.