thogge91

i got it bone stock un molested a couple months ago right now i just have the basics like exhaust boost controller mechanical boost gauge/air fuel and rims n tires. im also in the process of getting all the needed components for the 16g like injectors,fmic,fuel pump, dsmlink etc

thogge91

mines a 96 so im also doing the 2gb exterior swap

97DSModded

lol, well that's not a very warm welcome for a noob. If it seemed like I took your comments seriously, my bad. If everyone got butt hurt by every smartass comment made, we'd run out of preperation H pretty damn quick

The Nisbro

you've received a fairly warm welcome compared to others...just dont take anything to heart here, and you'll be fine.

TwistnBrn..Rubr

If you're going to highlight it, highlight the whole statement.

I'm giving you a heads up.

97DSModded

Nice. A 16g with the supporting mods can make for a pretty quick car, especially if you have AWD.

Here's my mod list so far

6 bolt being bored and honed
Eagle rods
Wiseco 9:1 compression pistons bored .30 over
FP2 cams
BC springs and retainers
3G lifters
FP 4 inch intake
FP3065 turbo with Tial wastegate (no open dump)
Aeromotive fuel rail and AFPR
Rewired walbro 255 fuel pump
DSMlink V3
Greddy FMIC
Greddy EBC
ACT 2600 clutch
Sheppard stage 3 tranny

97DSModded

lol, I was just giving you a hard time about the whole warm welcoming statement. No hard feelings

thogge91

nice, do you know of any dsm/mitsubishi meets coming up that are virginia/maryland/north carolina?

TwistnBrn..Rubr

This was warm. You haven't been flamed yet and it's already the second page, congratulations.

97DSModded

Unfortunately no lol. The one I'm probably going to, is the DSM/EVO shootout in Ohio in August. I just attend local car shows anymore. There's not a lot of EVO's or DSM's down this way. There is a dyno day in Wytheville, VA this saturday though. It's an AWD Mustang dyno, and it's only 35 bucks per 4 pulls. I wish I had my car done for this